The 3 Phase Insulated High Speed Galvanised Steel Shutter slats, provide Acoustic and Thermal Insulation. The high speed operation is ideal when forklifts are going in and out on a regular basis.
A popular choice for Warehouses, Distribution Depot and Industrial applications.
Benefit of Product
Insulated and High Speed
3 Phase - 415V - High Speed Motors
Wind Loading (EN 12424)
Up to Class 5
Acoustic Insulation (EN 717-1)
R = 27DB
Thermal Insulation (EN 13241)
UD = 3.9W/(M2K)
Galvanised finish. Powder Coating a BS or Ral Colours is available at an extra cost.
The standard Galvanised Steel Laths are Double skin, Insulated with anti vandal wind locks. Punched Window Laths are an additional cost. 77mm slat has a Heat transmission performance of 4.01 W/(m2K). The 95 mm and 100mm slat has a Heat transmission performance of 3.9 W/(m2K).
75mm and 95mm Laths
Industrial Doors come with a universal steel side end plates. The end plates are pre-drilled for different motors and motor configurations. As standard the industrial roller shutters, don't come with a Shutter hood, this is available at an extra cost if required.
This varies between 350mm - 550mm, dependent on the width of the opening, please contact us for the exact clear opening height for the particular width of shutter you require.
GUIDE RAIL SPECIFICATION
Traditional Guides are supplied with galvanised steel guide angle. The angle can be inset or outset if preferred, this must be clearly stated on your order. The thickness of angle varies as below;
77mm Insulated Laths - 95mm Guide with 75mm x 50mm Galvanised Steel Angle
95mm Insulated Laths - 80mm Guide with Brush Seals with 100mm x 50mm Galvanised Steel Angle
100mm Insulated Laths - 80mm Guide with Brush Seals with 100mm x 50mm Galvanised Steel Angle 100mm LATHS GUIDE DETAIL
The High Speed Insulated Industrial motors are available in 3 Phase (415V), sometimes a single phase inverter can be fitted. Depending on the size of the door with depend on the motor and what RPM they operate. The high speed motors usually operate from 8RPM up to 80RPM. The control panels allow the RPM to be adjusted to suit site requirements.
A high speed motors works by opening very fast ie; 8-45RPM, they close slower down to 2.5m above floor level ie: 8-28RPM and below 2.5m closer even slower. The motor slows down when closing due to Health and safety reasons.
As standard the motors come with a Chain Override. The high speed motors are available in ATEX rated for explosive environments. All these motors come with a 1 Year Manufacturer Warranty.
The Door Laths come as standard in White Aluminum Finish (RAL9006). Other colours are available at an extra cost and extended lead time.
Our Standard the finish on the Shutter Parts is Galvanised.